AXIOMTEK SBC8440 User Manual page 34

SBC8440 3.5
Form Factor SBC User's Manual


," ;
"'
7 
 
 
 

 .

$ "
?  

* 
2# #
<

  

 
 
 

?  


;#

Driver Installation - DOS Setup
Step 1. Install Windows as you normally do for a VGA display.
Run Windows to make sure it is working correctly.
Then exit from Windows.
Step 2. Place the Windows 3.1x Display Driver Diskette in
drive A. Type A:<ENTER> to make it be the default
drive. Type SETUP <ENTER> to run the driver SETUP
program. Press any key to get to the application list.
Using the arrow keys, select Windows Version 3.1 and
press the <ENTER> key. Press the <ENTER> key to
select All Resolutions, then press <END> to begin the
installation. At this point, you will be asked for the
path to your Windows System directory (default
C:\WINDOWS). When the installation is complete,
press any key to continue. Press <ESC> followed by Y
to exit to DOS.
Step 3. Change to the directory where you installed
Windows (usually C:\WINDOWS).
Step 4. Type SETUP <ENTER> to run the Windows Setup
program. It will show the current Windows
configuration. Use the "up" arrow key to move to
the Display line and press <ENTER>. A list of display
drivers will be shown. Use the arrow keys to select
one of the drivers starting with an asterisk (*) and
press <ENTER>.
Step 5. Follow the directions on the screen to complete the
setup. In most cases, you may press <ENTER> to
accept the suggested option. When Setup is done, it
will return to DOS. Type WIN <ENTER> to start
Windows with the new display driver.
1

Display Drivers