Installing Ac Power Supplies In The Cisco Asr 1001-X Router - Cisco ASR 1001-X Installation Manual

Chapter 7 Removing and Replacing FRUs from the Cisco ASR 1001-X Router
Figure 7-2
1
Repeat these steps if it is required to remove the other AC power supply.
Step 4
This completes the procedure for removing the AC power supplies from the Cisco ASR 1001-X Router.

Installing AC Power Supplies in the Cisco ASR 1001-X Router

Note Do not install the power supplies with the chassis cover off.
Follow these steps to install AC power supplies to the Cisco ASR 1001-X Router.
At the rear of the chassis, ensure that the power switch on the chassis is in the Standby position.
Step 1
Figure 7-3
Note
OL-32376-02
Removing the AC Power Supply
1
Retaining latch
shows the Cisco ASR 1001-X Router AC power supply Standby switch.
It is not required to place the power switch in the Standby position if you want to hot-swap a
single power supply.
Removing and Replacing the Cisco ASR 1001-X Router Power Supplies
Cisco ASR 1001-X Router Hardware Installation Guide
7-3