Cisco ASR 1001-X Installation Manual page 115

Chapter 7 Removing and Replacing FRUs from the Cisco ASR 1001-X Router
Figure 7-6
1 0.39 inch (10 mm) is the recommended wire-strip length for the terminal block.
Warning An exposed wire lead from a DC input power source can conduct harmful levels of electricity. Be sure
that no exposed portion of the DC input power source wire extends from the terminal block. Statement
122
Identify the positive and negative feed positions for the terminal block connection. The wiring sequence
Step 4
is:
Positive (+) lead wire (right)
1.
Negative (–) lead wire (left)
2.
Insert the exposed wire into the terminal block. Ensure that you cannot see any wire lead outside the
Step 5
plastic cover. Only wires with insulation should extend from the terminal block.
Do not overtorque the terminal block captive screws. Ensure that the connection is snug, but the wire is
Caution
not crushed. Verify by tugging lightly on each wire to ensure that they do not move.
Use a screwdriver to tighten the terminal block captive screws, as shown in
Step 6
OL-32376-02
Stripped DC Input Power Source Wire
1
Removing and Replacing the Cisco ASR 1001-X Router Power Supplies
Cisco ASR 1001-X Router Hardware Installation Guide
Figure 7-7.
7-7