Installing An Ssd Into The Nim-Ssd Module - Cisco ASR 1001-X Installation Manual

Chapter 7 Removing and Replacing FRUs from the Cisco ASR 1001-X Router
Figure 7-17
1
1. Tabs to pull out the SSD drive
Place the NIM-SSD in an antistatic bag to protect it from ESD damage.
Step 6
The completes the removal of the NIM-SSD.

Installing an SSD into the NIM-SSD Module

To install an SSD into the NIM-SSD module, follow these steps:
Step 1 On the NIM-SSD, loosen the captive screws that retain the SSD card slot cover, as shown in
Step 2 Pull the NIM-SSD card slot cover down, exposing the SSD slot, as shown in
Insert an SSD into the appropriate slot.
Step 3
The SSD(s) connector end should be inserted first, with the connector side facing down and the serial
Step 4
number facing up.
Pull the NIM-SSD card slot cover up and into place over the SSD.
Step 5
Verify that the NIM-SSD is installed correctly.
Step 6
Start the NIM-SSD module using the following steps:
Step 7
a.
b.
Use the show platform command as shown in
Step 8
in Example 7-2
Example 7-2
Router# show inventory
NAME: "Chassis", DESCR: "Cisco ASR1001-X Chassis"
PID: ASR1001-X , VID: V00, SN: P3A-9
OL-32376-02
Pulling Out the SSD
1
At the router# prompt, enter hw-module subslot 0/2 start and press Enter.
At the router# prompt, enter end and press Enter.
to verify whether the status of subslot 0/2 is OK.
show inventory Command
Removing and Replacing an SSD from the NIM-SSD Module
Example 7-1 and the show inventory command as shown
Cisco ASR 1001-X Router Hardware Installation Guide
Figure 7-15.
Figure 7-16.
7-21