Verifying The Initial Configuration - Cisco 819 Installation Manual

Chapter 4 Initial Configuration
Respond to the following prompts. Enter 2 to save the initial configuration.
Step 12
[0] Go to the IOS command prompt without saving this config.
[1] Return back to the setup without saving this config.
[2] Save this configuration to nvram and exit.
Enter your selection [2]: 2
Building configuration...
Use the enabled mode 'configure' command to modify this configuration.
Press RETURN to get started! RETURN
The user prompt is displayed.
Router>
Step 13 Verify the initial configuration. See the
verification procedures.
After the initial configuration file is created, you can use the Cisco IOS CLI to perform additional
configuration.

Verifying the Initial Configuration

To verify that the new interfaces are operating correctly, perform the following tests:
•
•
•
After you complete and verify the initial configuration, you can configure your Cisco router for specific
functions.
OL-23125-02
To verify that the interfaces and line protocol are in the correct state—up or down—enter the show
interfaces command.
To display a summary status of the interfaces configured for IP, enter the show ip interface brief
command.
To verify that you configured the correct hostname and password, enter the show configuration
command.
"Verifying the Initial Configuration" section on page 4-5
Cisco 819 Integrated Services Router Hardware Installation Guide
Verifying the Initial Configuration
for
4-5