Using Handset Wall Holder; Locating Lighting, Operation And Rating Information Plate; Servicing Your Fireplace; Fireplace Control Devices - Valor 785JLN Owner's Manual

OWNER'S
INFORMATION
5. Replace the cover and screw in place.
6. Reconnect the battery box.
7. Put the battery box back in its position.
8. Reinstall the left access door.

Using Handset Wall Holder

Your fi replace equipment includes a wall
holder to store the handset. If it hasn't be
installed, refer to the instructions further on
in this manual for the installation.
Locating Lighting, Operation and
Rating Information Plate
WARNING
WARNING
!
DO NOT ATTEMPT TO TOUCH THE DATA PLATE
WHILE THE FIREPLACE IS STILL HOT! Let the
fi replace cool fi rst before touching it.
The Lighting, Operation and Rating information is
located on a plate at the right of the fi rebox. To access
the plate, remove the right hand side door, grab the
plate and take it out to read it. There is important
information on both sides of the plate.

Servicing Your Fireplace

If any attention is required for your appliance, contact
your supplier quoting the model number. It will be help-
ful if the appliance's serial number can also be quoted.
This number is on the rating plate, which is located at
the right of the fi rebox. The replacement parts are shown
at the end of this manual. Please always quote the part
number and description when requesting spare parts.

Fireplace Control Devices

There are three ways to control your fi replace.
1. Thermostatic Remote Control;
2. Wall Switch (optional);
3. Manual On/Off Switch.
The manual On/Off switch must be ON for the
fi replace to function. It can be used to shut off
the fi replace in case of emergency—see next
sub-section.
The Thermostatic Remote Control can
be programmed to function
automatically—see pages 9–14.
The Wall Switch (optional) can be
used to turn on, off and to increase
or decrease the fl ame height—see
1265WSK—Wall Switch Kit.
NOTE: The remote control in the
AUTO mode will override the wall switch.
8
Owner's Information
How to Turn Your Fireplace OFF
Familiarize yourself with each of these methods before
operating your fi replace.
Handset and Wall Switch: Press and hold the OFF
button for a second.
If the fl ames are on, they go down and you hear the
valve motor wind down. You hear a clunk and a beep
indicating that the valve has received the signal from
the remote control.
Manual ON/OFF Switch: Press the O button.
How to Ensure Your Fireplace Cannot
Be Turned ON Inadvertently
You can use one of the two following methods to
ensure that your fi replace will not turn on when you
don't want it on.
First, ensure your fi replace is turned off—including
the pilot—and cold BEFORE going ahead.
• Press the O button on the manual ON/OFF switch
Manual On/
Off Switch
• Alternately, remove all batteries from the receiver as
Automatic Shut-Off (in certain conditions)
Your fi replace's remote control is equipped with an
automatic shut-off mechanism which is activated in
Thermostatic Wall Switch
certain conditions. See page 14 in the Remote Control
Remote (optional)
Operation section for a description of this feature.
Control
Remote control
handset
ON
OFF
Manual ON/OFF Switch
on the gas valve—see image above.
well as the battery from the handset.
(including pilot)
Wall Switch
(optional)