Install Side Shrouds; Install Front, Trim And Barrier Screen; Install Handset Wall Holder - Valor 785JLN Owner's Manual

QUALIFIED
INSTALLER

Install Side Shrouds

The side shrouds are required to install the front on
the appliance. They are supplied with the engine.
Fit them to the appliance outer case as indicated
(2 screws/side).
See instructions supplied with the front trim for
installation of trim.

Install Front, Trim and Barrier Screen

Install the front or trim chosen by the customer for their
fi replace. Install as well the barrier screen which is
provided with the front or trim.
Show the customer how to access the controls when
the front or trim are installed and how to remove them.
Follow the instructions provided with the front or trim
and leave those instructions behind for the customer's
further reference.

Install Handset Wall Holder

The remote control kit for this fi replace
comes complete with a wall-mounted holder.
This holder is not required in all installations
but is provided as an optional feature for
those customers who wish to mount the
remote handset to the wall.
To install the holder to the wall, fi nd a
convenient location and use the hardware
provided with the kit. See the diagram below
for required hardware and confi gurations.
Note that the holder can be installed at the
base of a light switch plate.
IMPORTANT. The location of the remote
control handset is important to assure proper temperature regulation. To obtain a constant temperature, we
recommend that the handset should be between 3 and 15 feet away from the appliance but not directly above it.
We also advise that the handset should be located away from any other heat source and not in direct sunlight as
this may affect the temperature sensor located in the remote handset.
34
Installation
Packing Contents:
1 Wall Bracket A
2 Screws B
1 Screw C
2 Wall Anchor D
1 Spacer E
(detach before assembly)
1 Wall Bracket F
Alternative 1
Door hinge tabs
should face inwards
Alternative 2
Alternative 3
Switch Plate