Dmx; The Menu Field - GLP IMPRESSION 120 RZ WWC Instruction Manual

2.3.2 DMX

USITT DMX-512 Standard input/output with 3 pole connectors.
3 pole: Pin 1 = [Ground] / Pin 2 = [-] / Pin 3 = [+]
The DMX- Addressing starts at DMX- Address [001].

3 The Menu Field

You'll find the control board on the side of the arm. It allows you to make
all necessary adjustments of the
get into the main menu. Afterwards you can navigate through the menu
with the Up/Down-keys. Push the Enter-key to get to the next menu
level or to confirm your settings. Select ON/ OFF function settings with
the Up/Down-keys. Confirm and save with the Enter-key (the display
shows OK). Push the Mode-key to cancel the entry and go back to the
main menu.
Level1 Level 2
DMX Start
Address 001
Special Manual DMX
Display
Contrast
Default Set
Set Dimmer
Frequency
LED Dimmer
Version
Impression
Version
Adjust
GLP German Light Products GmbH
W W C &
W W C &
W W C &
I M P R E S S I O
I M P R E S S I O
Level 3 Level 4
Pan
Speed
Movements
Pan/Tilt
Movements
Special
Dimmer
Shutter
1/3 White
2/3 White
Zoom
Tilt
Key code
xxxx
Pan Offset
Tilt Offset
(Instruction version 1.14) / from software version 1.00/03)
C C W
C C W
C C W
N . With the Mode-key you
N .
Remark
Define the DMX start address
Manual control of all system functions
Manual control for Pan (X-movement)
Speed adjustment for Pan/Tilt movements
also item below
Manual control for Pan/Tilt movement
Activate the White- or Full-Power Mode; see also
DMX table
Manual control for dimmer
Manual control for shutter
Manual control for 1/3 white, 30x LEDs (either warm-
or cold white depending on the system)
Manual control for 2/3 white, 60x LEDs (either warm-
or cold white depending on the system)
Manual control for zoom
Manual control for tilt (Y-movement)
Adjustment for the Display contrast
Resetting all functions to original values
Changes PMW frequency between 600Hz and
1200Hz
Reads out the current LED dimmer (software) version
Reads out the current CPU software version
Use the code for entering the calibration menu (for
authorized persons only)
Calibration for Pan-Offset
Calibration for Tilt-Offset
Mo d e Do wn
Ente r Up
see
10