Ricoh 917F Operating Instructions Manual page 1761

Message
"Cannot start scanning.
Check the setting(s) on the
PC."
"Cannot write on memory
device because remain.
space is insufficient."
"Cannot write on memory
device because the device is
write-protected."
"Cannot write on memory
device. Check memory
device and machine sett."
"Check the resolution and
reset nnn original(s)."
(A figure is placed at nnn.)
"Communicating..."
Cause
The Scan Profile might be
incorrectly configured.
The memory device is
insufficient and scan data
cannot be saved.
The memory device is write
protected.
The memory device is faulty,
or the file name contains a
character that cannot be
used.
The scanned original
exceeded maximum data
capacity.
Data is being prepared for
sending to a client computer.
Messages Displayed When Using the Scanner Function
Solution
Check the Scan Profile configuration.
Replace the memory device.
Unlock the write-protection on the
memory device.
• Check to see if the memory device
is defective.
• Check the memory device. It might
be unformatted, or its format might
be incompatible with this machine.
• Check the file name set at the time
of scanning. For details on the
characters that can be used in file
names, see "Values of Various Set
Items for Transmission/Delivery
Function", Scanner Reference
Check with your system
administrator.
Specify the scan size and resolution
again. Note that it may not be possible
to scan very large originals at a high
resolution. See "Relationship between
Resolution and Scan Size", Scanner
Reference .
Wait until the data has been sent. This
message might reappear if the machine
is operating on a mixed network or if
changes were made to network settings
during WSD scanning transmission.
Check with your system administrator.
5
.
83