Acceptable Original Sizes; Paper Size And Scanned Area - Ricoh 9050b Operating Instructions Manual

1. Transmission

Acceptable Original Sizes

This section describes the size and thickness limitations that apply to originals placed on the exposure glass
1
or the ADF.
Where original is set
Exposure glass
ADF, one-sided
original
ADF, two-sided
original
• The weight range for originals in the Mixed Original Sizes mode is 52-81.4 g/m

Paper Size and Scanned Area

This section explains the size of the area the machine can scan and detect.
• There may be a difference in the size of the image when it is printed at the destination.
• Even if an original is correctly placed on the exposure glass or in the ADF, a margin of 3 mm (0.1
inch) around each edge of the original may not be sent.
• If the receiver uses paper of a smaller width than the original, the image is reduced to fit that paper.
See "Auto Reduce".
• p.169 "Auto Reduce"
When placing an original on the exposure glass
This section explains how to place an original on the exposure glass.
• If you place an original larger than A3, 11 × 17 on the exposure glass, only an A3, 11 × 17 area
is scanned.
50
Acceptable original size
Up to A3 (297 × 420 mm),
11 × 17 (279 × 432 mm)
B6 JIS to A3 (up to 1200 mm long)
1 1
5 / × 8 / to 11 × 17
2 2
A5 to A3 (up to 432 mm long)
1 1
5 / × 8 / to 11 × 17
2 2
Maximum number Paper
of sheets thickness
1 sheet
100 sheets 40-128 g/m
2
(80 g/m , 20 lb) (11-34 lb)
100 sheets 52-128 g/m
2
(80 g/m , 20 lb) (14-34 lb)
2
, 13.8-21.5 lb.
2
2