Changing The Line Port - Ricoh 9050b Operating Instructions Manual

Changing the Line Port

Select a line port or protocol to be used for standard fax or IP-Fax transmission.
When the extra G3 interface unit is installed, you can connect to a maximum of three ports.
• To add more fax lines, the optional extra G3 interface unit is required.
G3
G3 is selected after power up or when the machine is reset. If you install the extra G3 interface unit,
you can select "G3-1", "G3-2", "G3-3", or "G3 Auto" depending on the number of the installed
unit.
Multi-port
When the extra G3 interface unit is installed, communications can take place simultaneously through
three lines at once.
The following list shows protocol combinations available for each line type.
Option
Without option
Extra G3 interface unit
Extra G3 interface unit
G3 interface unit
IP-Fax
When sending an IP-Fax, select either "SIP" or "H.323" as the protocol.
To display "SIP" and "H.323" on the screen, make the settings in "Initial Settings" in the Facsimile
Features menu. If you are using SIP, specify "Enable SIP" and "SIP Settings". If you are using H.323,
Available line types
PSTN
PSTN PSTN
Extra PSTN PSTN PSTN
Changing the Line Port
Available protocol
combinations
G3
G3 G3
G3 G3 G3
1
73