Commissioning; Commissioning The Telephone - Auerswald COMfortel 1200 Setup Manual

Commissioning

This section describes how to commission the telephones and the answering machine on the
COMfortel 1400 for the first time in a stepwise procedure. After a successful initial commis-
sioning, you will be able to make calls. You can customise your telephone and the answering
machine using the PC configuration described at the end of this section.

Commissioning the Telephone

Requirements
– PBX, switched on (connected to 230 V mains)
– The internal telephone number for the telephone entered in the configura-
tion on the internal S
Note: Only connect one ISDN device for each internal subscriber tele-
phone number to your PBX.
– PBX with at least the following firmware version:
Note: If necessary, carry out an update of the PBX (see instructions of the
PBX).
1.
Insert the plug of the ISDN cable included in the package into the jack
marked with
Fig. 15: Connecting to the PBX
46
Commissioning
0
COMpact 3000: 4.0L
COMpact 2206 USB and COMpact 4410 USB: 2.4A
COMpact 5000/R: 6.2A
COMpact 5010 VoIP and COMpact 5020 VoIP: 4.2E
COMmander 6000/R/RX: 6.0C
on the bottom of the telephone.
COMfortel 1200/1400 - Firmware Version 1.4 - COMfortel Set 3.6.0 - Setup V01 04/2014
or U port on the PBX
P0