To Adjust The Idle Speed; Throttle Cable Play; To Adjust The Cable Play - Suzuki GSX1300R Owner's Manual

NOTE: About 3100 ml (3.3/2.7 US/
Imp. qt) of oil will be required when
changing oil only.
A CAUTION
Engine damage may occur if you
use oil that does not meet Suzuki's
specifications.
Use the oil specified in the FUEL,
ENGINE OIL AND COOLANT REC-
OMMENDATION section.
3
fully for leaks at the oil filter and
drain plug. Run the engine at vari-
ous speeds for 2 to 3 minutes.
minutes. Check the oil level again.
Engine oil level can be inspected
through the inspection window
while holding the motorcycle ver-
I
tically. If the oil level is lower than
the "F" line, add new oil until it
reaches the "F" line. Check for
leaks again.
J
NOTE: If you do not have a proper oil
filter wrench, have your Suzuki dealer
perform this service.
1
J
IDLE SPEED
Adjust the engine idle speed periodi-
cally on the engine at normal operat-
ing temperature.

To adjust the idle speed:

gine run until it warms up fully.
2. After engine warms up, turn the
throttle stop screw knob ® in or out
so that engine may run at 1050 -
1250 r/min.
NOTE: The idle speed should be ad-
justed with the engine fully warmed up.
56
descargado de www.IMPERATOR.tk - VIRTUAL MOTORCYCLE CLUB

THROTTLE CABLE PLAY

This motorcycle has a twin throttle
cable system. Cable ® is for pulling
cable and cable ® is for returning.

To adjust the cable play:

2. Turn in the adjuster (D fully.
3. Loosen the lock nut ®.
4. Turn the adjuster ® so that the
throttle grip has 2.0 - 4.0 mm (0.08
5. Tighten the lock nut (3).
6. While holding the throttle grip at the
closed position, turn out the ad-
juster @ to feel resistance.
7. Tighten the lock nut ®.
57
A WARNING
Inadequate throttle cable play can
cause engine speed to rise sud-
denly when you turn the handle-
bars. This can lead to loss of rider
control.
Adjust the throttle cable play so
that engine idle speed does not rise
due to handlebars movement.