Clock/Fuel Injection System Indicator/Clock Mode; Speedometer; Coolant Temperature Meter; Neutral Indicator Light - Suzuki GSX1300R Owner's Manual

Hide thumbs Also See for GSX1300R:
Table of Contents

Advertisement

J
1
1
I
INDICATOR (D
The indicator displays clock under
normal condition. The indicator
1
switches from the clock to the fuel in-
jection system indicator if the fuel in-
jection system has any failure.
1
Clock mode
The clock indicates 12-hour mode.
Follow the procedure below to adjust
the clock.
1. Push the button® until the display
blinks.
2. Pushing the button will advance
3
one minute at a time. Repeat push-
ing the button until the display
reaches desired time.
3. Keeping the button pushed in will
advance ten minutes at a time.
Keep the button pushed until the
display reaches desired time. Fine-
tune the time by pushing the but-
ton repeatedly.
4. Wait 5 seconds and push the but-
ton to resume to time display.
Fuel injection system indicator
F I
The fuel injection system indicator in-
dicates "Fl" or "CHEC" if the fuel in-
jection system has any trouble. The Fl
indicator light (D will also come on if
the fuel injection system has failure.
No
Fuel
Fl
Engine
injection
indicator
condition
system
light
indicator
1
Fl
Blinks
Engine
does not
start.
2
Lights
Engine
alternately
can start.
3
CHEC
Engine
-
does not
start.
If the fuel injection system indica-
tor displays "Fl" and Fl indicator
light blinks, the engine will not start
due to a serious fuel injection sys-
tem failure. If the system has seri-
ous failure while riding, the engine
may stop.
When the fuel injection system in-
dicator displays "Fl" and clock al-
ternately and Fl indicator light
comes on, the engine can be
started and a will keep running with
limited engine performance. This
shows that the fuel injection sys-
14
descargado de www.IMPERATOR.tk - VIRTUAL MOTORCYCLE CLUB
tem has minor failure. Bring your
motorcycle to an anthorized Suzuki
dealer or qualified mechanic to in-
spect the motorcycle. Continuous
operation in this condition may se-
riously damage the motorcycle.
3. When the fuel injection system in-
dicator indicates "CHEC," the en-
gine will not start. Make sure that
the engine stop switch is turned on
and the transmission is in neutral
position with the side stand fully up.
If the indicator still indicates
"CHEC," inspect the ignition fuse
next.
SPEEDOMETER ®
The speedometer indicates the road
speed in kilometers per hour and miles
per hour.
RIGHT TURN SIGNAL INDICATOR
LIGHT ©
When the right turn signals are oper-
ated, the indicator light will flash at the
same time.
NOTE: If the turn signal light is not op-
erating properly due to bulb filament
or circuit failure, the indicator light flick-
ers more quickly to notify the rider of
the existence of trouble.
15

COOLANT TEMPERATURE METER

®
The coolant temperature meter indi-
cates coolant temperature. When the
coolant temperature gets too much
high, the coolant temperature indi-
cator light ® comes on.
A CAUTION
Running the engine with high en-
gine coolant temperature can
cause serious engine damage. If
the engine coolant temperature in-
dicator light comes on, stop the
engine to let it cool.
Do not run the engine run until the
coolant temperature indicator goes
off.
NOTE: The needle points "H" when the
engine stop switch is turned to the
"OFF" position with the ignition switch
in "ON" position.
NEUTRAL INDICATOR LIGHT ®
The indicator light will come on when
the transmission is in neutral. The light
goes off when you shift into any gear
other than neutral.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents