Epson Runsense SF-810 User Manual page 94

SF-810 User Manual
Setting items
Target Pace
HR
Alarm
Tap
(Only for the
measurement screen)
GPS
Screen
Settings
Value
SETTING 01 to 03
OFF (default)
ON (default)
OFF
Tones
Vib. (vibration)
Tones & Vib. (vibration)
(default)
OFF
Lap
Light
Screen Chg.
OFF (default)
-
Screen1
Screen2
Screen3
Screen4
Display Lap Screen
Explanation
Set the target time and pace range for one kilometre/
mile. An alarm sounds if you are outside the set pace
range.
You can set three target paces within the following
range.
Target Pace: 1'00" to 15'00"/km or miles (in increments of
1 second)
Pace Range: 00'05" to 03'00"/km or miles (in increments
of 1 second)
"Setting a Pace and Measuring (Target Pace
U
Function)" on page 59
You can measure pulse (heart rate) with the built-in
sensor.
"Measuring Pulse (Heart Rate) during Exercise" on
U
page 38
Set the alarm type and time (1 to 10 minutes).
You can also set this from Sys. Settings.
You can perform one of the operations set here by
tapping the screen until the alarm sounds while
measuring.
When Bike is selected as the Activity Type, the tap
function may operate automatically depending on the
condition of the road surface. If this occurs, we
recommend to change the setting to OFF.
"Tap" on page 21
U
Displays the number of GPS satellites being accessed.
You can display up to four measurement screens. You
can change the screen pattern and the measurement
items displayed for each screen.
You can also change the Display Lap Screen, but this is
not displayed for the interval function.
"Screen" on page 100
U
94