Gps Positioning; Indoor Mode - Epson Runsense SF-810 User Manual

SF-810 User Manual

GPS positioning

When you change to the measurement screen, the
device receives a signal from various satellites, and
identifies your position to use for measurement.
c
Important:
While identifying a GPS, make sure you are
outside with no obstructions overhead, and try to
keep the device as still as possible.
Operation buttons
A
Go to a location outside with no
obstructions overhead.
B
Perform GPS positioning.
Press C.
GPS positioning starts.
When GPS positioning is complete, the
measurement screen is displayed.
Preparing and Basic Operations
When the measurement screen is displayed, you can
start measuring.
"Measure" on page 37
U
Skipping GPS positioning
If you want to start measuring immediately, or if GPS
positioning is taking too long, select Skip during GPS
positioning and start measuring.
GPS positioning continues while measuring, and when
positioning is complete the device starts recording
positional information. The routes before GPS
positioning is complete and while using indoor mode
are not recorded. Distance and pace data can still be
measured. The device will use the stride sensor until a
GPS connection is made.
"Measurable Items" on page 35
U

Indoor mode

This function allows you to measure without
performing GPS positioning. Use this when GPS
positioning cannot be performed because you are
indoors and so on.
The route and so on is not recorded in indoor mode.
Also, measurement items are limited in indoor mode.
"Measurable Items" on page 35
U
31
Note:
It usually takes less than two minutes to complete
GPS positioning.
If it takes more than two minutes and Failed is
displayed, we recommend selecting Cancel,
moving to a different location, and trying again.