Measure Settings; Changing The Measure Settings - Epson Runsense SF-810 User Manual

SF-810 User Manual

Measure settings

Allows you to change the measurement settings.

Changing the Measure settings

c
Important:
❏ When performing GPS positioning, make
sure the screen is facing up and you are
outside with no obstructions overhead.
"Specifying a GPS (GPS Positioning)" on
U
page 30
❏ It usually takes less than two minutes to
complete GPS positioning.
If it takes more than two minutes and Failed
is displayed, we recommend selecting
Cancel, moving to a different location, and
trying again.
Operation buttons
A
Display the measurement screen.
Use one of the following methods to display.
❏ When performing GPS positioning:
Press C on the time screen.
❏ When skipping GPS positioning:
Press C on the time screen, and then select
Skip on the GPS positioning screen.
"Skipping GPS positioning" on
U
page 31
❏ When not performing GPS positioning
(Indoor mode):
Press C on the time screen, and then select
Indoor on the GPS positioning screen.
Settings
"Indoor mode" on page 31
U
B
Display the Measure set. menu.
Hold down B on the measurement screen.
C
Select a setting item.
Use C/D to select, and then press A.
D
Select a setting value.
Use C/D to select, and then press A.
Depending on the selections, you may need to
choose further settings. Follow the on-screen
instructions.
Note:
When setting a number, hold down C/D to speed
through the numbers.
E
Complete the settings.
Hold down A.
91