Master/Slave Configuration - ADJ INNO ROLL HP User Instructions

Table of Contents

Advertisement

Inno Roll HP
being the least sensitive and "100" being the most.
3. The optional UC3 Controller (not included) may be used to con-
trol different functions including blackout.
Show Mode:
This mode allows either a single unit or several units
linked together, to run one of four shows that you choose.
1. Press the MENU button until
press ENTER.
2.
Press the UP or DOWN buttons until you find your desired show,
and press ENTER.
ADJ Products, LLC - www.adj.com - Inno Roll HP Instruction Manual Page 16
Operation
"Show Mode" is displayed, and
Inno Roll HP
Master-Slave Configuration
to 16 units together and operate without a controller. The units will
be sound activated. In Master-Slave operation one unit will act as the
controlling unit and the others will react to the controlling units pro-
grams. Any unit can act as a Master or as a Slave.
1. Using approved DMX data cables, daisy chain your units togeth-
er via the XLR connector on the rear of the units. Remember the
Male XLR connector is the input and the Female XLR connector
is the output. The first unit in the chain (master) will use the female
XLR connector only - The last unit in the chain will use the male
XLR connector only. For longer cable runs we suggest a termina-
tor at the last fixture.
2. On the Master unit find your desired show and set that show by
pressing the ENTER button.
3. On the slave units tap the MENU button until "Slave Mode" is
displayed, and Press ENTER. Choose either "Slave 1" or "Slave
2" and press ENTER. See page 10for more info.
4. The slave units will now follow the Master unit.
Inno Roll HP
Stand by
Blackout the unit
Function
1.
Strobe in synchronization
2.
strobe in desynchronization
3.
Strobe by music
Mode
Sound
(LED OFF)
ADJ Products, LLC - www.adj.com - Inno Roll HP Instruction Manual Page 17
Master-Slave Configuration
This function will allow you to link up
UC3 Control
Select Movement
Color/Gobo selection
1-6
1.
Press shortly for
color change.
2.
Hold on for
Gobo change
Movement
Gobo/Color
(LED Blinking)
(LED ON)

Advertisement

Table of Contents
loading

Table of Contents