Software Version - ADJ INNO ROLL HP User Instructions

Inno Roll HP
unit will automatically go into Master Slave mode.
• Blackout - If the DMX signal is lost or power is applied, the unit
will automatically go into stand by mode.
• Last State - If the DMX signal is lost the fixture will stay in the
last DMX set up. If power is applied and this mode is set, the unit
will automatically go into the last DMX set up.
3. Press ENTER to confirm your desired set up.
Back Light
- With this function you can make the back-
light automatically turn off after one minute.
1. Press the MENU button until "Back Light" is displayed, press
ENTER.
2. Either "ON" or "OFF" will now be displayed. Press the UP or
DOWN buttons to select "ON" to keep the backlight on at all
times, or "OFF" to allow the backlight to turn off after 2 minutes.
Press any button to turn the backlight on again.
3. Press ENTER to confirm.
Pan Invert
- Pan Inversion
1. Press the MENU button until "Pan Invert" is displayed, press
ENTER. Either "Yes" or "No" will be displayed.
2. To activate the Pan inversion press the UP or DOWN buttons
until "Yes" is displayed, press ENTER to confim. To deactivate
Pan inversion, select "No" and press Enter.
Auto Test
- This function will run a self test program.
1. Press the MENU button until "Auto Test" is displayed, press
ENTER.
2. The fixture will now run a self test. Press the MENU button to
exit.
ADJ Products, LLC - www.adj.com - Inno Roll HP Instruction Manual Page 12
System Menu Inno Roll HP
Fixture Temp.
running temperature of the unit.
1. Tap the MENU button until "Fixture Temp." is displayed,
press ENTER.
2. The current running temperature of the fixture will now be
displayed. Press MENU to exit.
Function Hours
the running time of the unit.
1. Press the MENU button until "Function Hours" is displayed,
press ENTER.
2. The running time of the fixture will now be displayed. Press
MENU to exit.

Software Version

sion.
1. Tap the MENU button until "Software Version" is displayed.
Press the ENTER button and the software vesion will be dis-
played.
2. Press the MENU button to leave this function.
Defaults
1. Tap the MENU button until "Defaults" is displayed. Press the
ENTER button and either "Yes" or "No" will be displayed.
2. Press the MENU button to leave this function.
Restart
1. Tap the MENU button until "Restart" is displayed, press
ENTER.
2. The fixture will now reset.
- With this function you can display the
- With this function you can display
- This will display the software ver-
- This will reset the unit to its default settings.
- Use this function to reset the unit.
ADJ Products, LLC - www.adj.com - Inno Roll HP Instruction Manual Page 13
System Menu