Table of Contents
Advertisement
3. You must check the operation of the model before
every flight to insure that all equipment is operating
and that the model has remained structurally
sound. Be sure to check clevises or other
connectors often and replace them if they show any
signs of wear or fatigue.
4. If you are not an experienced pilot or have not
flown this type of model before, we recommend
that you get the assistance of an experienced pilot
in your R/C club for your first flights. If you're not a
member of a club, your local hobby shop has
information about clubs in your area whose
membership includes experienced pilots.
Before starting to build, take an inventory of this kit to make sure it is complete, and inspect the parts to
make sure they are of acceptable quality. If any parts are missing or are not of acceptable quality, or if you
need assistance with assembly, contact Product Support. When reporting defective or missing parts, use
the part names exactly as they are written in the Kit Contents list.
Hobbico Product Support • 3002 N Apollo Drive, Suite 1 • Champaign, IL 61822
1
2
3
4
5
Items photographed
1. Left wing
2. Right wing
3. Fin & rudder
4. Fuselage (servos, receiver &
engine preinstalled
5. Spinner
6. Langing gear
7. Stab with elevators
Kit Inspection
Telephone: (217) 398-8970, ext. 2 • Fax: (217) 398-7721
E-mail: airsupport@hobbico.com
8. Misc. hardware (Itemized after
this list)
9. Radio system & charger.
Miscellaneous hardware list
(1) 9 x 207mm metal wing joiner
(2) 56mm plastic stab bolts
(2) Metal wing joiner straps
(2) Nylon landing gear straps
(4) Plastic wing dowel plates
We, as the kit manufacturer, provide you with a
top
quality,
instructions, but ultimately the quality and
flyability of your finished model depends on how
you build it; therefore, we cannot in any way
guarantee the performance of your completed
model, and no representations are expressed or
implied as to the performance or safety of your
completed model.
Remember: Take your time and follow the
instructions to end up with a well-built model.
Kit Contents
3
thoroughly
tested
(2) 7 x120mm wood dowels
(8) 2.5 x 8mm screws for mounting
the plastic wing dowel shrouds
(4) 3 x 12mm screws for mounting
the landing gear straps
(8) Rubber bands
Nylon clevises
(4)
(These threaded
clevises are in addition to the clevises
already installed on the pushrods. These
are provided as extras.)
kit
and
6
7
8
9
Advertisement
Table of Contents
