Performing a Blind Transfer
To perform a blind transfer:
1. During a call, press the Trnsfer soft key.
2. Press the Blind soft key.
3. Do one of the following steps:
— Enter the number to which you want to transfer the call.
At this point, the call is connected to the number to which you areTransferring
them.
Forwarding Calls
You can configure your phone so that all incoming calls are forwarded toanother party
(refer to
Static
Forwarding). You can also forward calls while your phone rings (refer to
Dynamic
Forwarding).
You can forward all incoming calls to another party while Do Not Disturb isenabled on
your phone. For more information, contact your systemadministrator.
Static Forwarding
To forward all incoming calls to another party:
1. From the idle screen, press the Forward soft key.
3. Press the Up or Down soft keys to increase or decrease the displaycontrast.
You can also use the volume keys to increase or decrease the display contrast.
4. Press the Ok soft key.
5. Press
to return to the idle screen.
Changing the Backlight Intensity
Backlight intensity on the SoundPoint IP 450 phone has three components:
• Backlight On
• Backlight Idle
• Maximum Intensity
You can modify the Backlight On intensity and the Backlight Idle intensity separately.
You can select high, medium, low, and off levels for both.
When you modify the Maximum Intensity, you are modifying the entire backlight
intensity scale. For example, if you decrease the Maximum Intensity, the low, medium,
and high values for both Backlight On intensity and the Backlight Idle intensity
decrease.
The Backlight On intensity applies for the following events:
• Any key press
• Hookswitch release
• Incoming calls
• Ending a call, holding a call, resuming a call by the other party
• A voice or instant message received
If you do not press any keys on the phone after 20 seconds of the backlight
turning on, the backlight dims (or changes) to medium in the following cases:
• A call is in progress
• A call is on hold
• There is an incoming call (ringing)