Gate Overlap Setting - Viking X-9 Installation Instructions And Safety Information

SPECIAL FEATURES SPECIAL FEATURES

Gate Overlap Setting

Setting the Overlap Delay Pot to "0" will cause the master and the slave units to
open and close at the same time
A Master/Slave control board is required to
operate two gates with a single controller.
(Master/Slave Unit Board shown)
Setting the Overlap Delay Pot to any value
other than zero will cause the master unit to
delay in opening.
The time delay can be set for up to 3 seconds.
Master Unit
TECHNICAL SUPPORT 1 800 908 0884
Trim Pot Location
Outside
Inside
Overlap Delay
1.5
3
mit
Hold Open
Timer
Opens First
Obstruct
Sensor
0
Slave Unit
27