Photo Beam (Non-Contact Sensor) Installation - Viking X-9 Installation Instructions And Safety Information

IMPORTANT SAFETY INFORMATION IMPORTANT SAFETY INFORMATION
WARNING - Not following these instructions may cause severe injury or death to persons.

Photo Beam (non-contact sensor) Installation

Photo beams or like must be installed to reduce the risk of entrapment.
Use only UL325 compliance devices like:
Omron E3K-R10
Ensure that any device installed is UL325 compliant and low voltage device (24 VDC).
Read the device manual for proper installation, and proper connection (especially
the polarity of the device).
ands ands Safety Connector Safety Connector
One or more non-contact sensors shall be located where
the risk of entrapment or obstruction exists, such as the
perimeter reachable by a moving gate or barrier.
Consult the installation manual for the UL325 device
(photo beam or like) for detail information about the
usage, installation and maintenance
6
N
Radio Sta Radio Sta
Connection '1' (C1)
Connection '3' (NC1)
24 VDC Power Connections
24 VDC Power Connections
Photo Beam Unit
Gate in Open Position
TECHNICAL SUPPORT 1 800 908 0884
1 1 3 3
24VDC 24VDC
(C1) (C1) (NC1) (NC1)
Potential Entrapment
Area (Shaded)
Turn Switch to
'Light On' Position
Omron Model
E3K-R10
Shown
Reflector