Table of Contents
Advertisement
Troubleshooting
Replace paper pick rollers in [paper source], use parts and instructions in tray 1 or
tray 2 compartment [80]
Try one or more of the following:
•
Replace the pick rollers, and then touch Rollers replaced on the control panel to clear the message and continue
printing.
•
Touch Replace later (jams may persist) to ignore the message and continue printing.
Replace photoconductor, 0 pages remain [84.xy]
Replace the photoconductor unit to clear the message and continue printing. For more information, see the instruction
sheet that came with the supply or see
Note: If you do not have a replacement photoconductor unit, then see
www.lexmark.com.
Replace unsupported cartridge [32.xy]
Remove the toner cartridge, and then install a supported one to clear the message and continue printing. For more
information, see the instruction sheet that came with the supply or see the "Replacing supplies" section of the User's
Guide.
Note: If you do not have a replacement cartridge, then see the "Ordering supplies" section of the User's Guide or
visit www.lexmark.com.
Replace unsupported photoconductor [32.xy]
Remove the photoconductor unit, and then install a supported one to clear the message and continue printing. For
more information, see the instruction sheet that came with the supply or see
page
136.
Note: If you do not have a replacement photoconductor unit, then see
www.lexmark.com.
Replace waste toner bottle [82.xy]
Replace the waste toner bottle to clear the message.
Restore held jobs?
Try one or more of the following:
•
From the printer control panel, touch Restore to restore all held jobs stored in the printer hard disk.
•
From the printer control panel, touch Do not restore if you do not want to restore any of the print jobs.
"Replacing a photoconductor unit" on page
136.
"Ordering supplies" on page 134
"Replacing a photoconductor unit" on
"Ordering supplies" on page 134
196
or go to
or go to
Advertisement
Table of Contents
