Restore Held Jobs - Lexmark MS810 Series User Manual

Troubleshooting
Replace roller kit [81.xx]
1
Replace the roller kit. For more information, see the instruction sheet that came with the part.
2
Press to clear the message and continue printing.
Replace unsupported cartridge [32.xy]
Remove the toner cartridge, and then install a supported one to clear the message and continue printing. For more
information, see the instruction sheet that came with the supply or see the "Replacing supplies" section of the User's
Guide.
Note: If you do not have a replacement cartridge, then see the "Ordering supplies" section of the User's Guide or
visit www.lexmark.com.
Replace unsupported fuser [32.xy]
Remove the fuser, and then install a supported one. For more information, see the instruction sheet that came with
the part.
Replace unsupported imaging unit [32.xy]
Remove the imaging unit, and then install a supported one to clear the message and continue printing. For more
information, see the instruction sheet that came with the supply or see the "Replacing supplies" section of the User's
Guide.
Note: If you do not have a replacement imaging unit, then see the "Ordering supplies" section of the User's Guide or
visit www.lexmark.com.

Restore held jobs?

Try one or more of the following:
•
Select Restore on the printer control panel to restore all held jobs stored in the printer hard disk. For
non‑touch‑screen printer models, press
•
Select Do not restore if you do not want any print jobs to be restored. For non‑touch‑screen printer models, press
to confirm.
Serial port [x] disabled [56]
Try one or more of the following:
• Select Continue to clear the message. For non-touch-screen printer models, press
The printer discards any data received through the specified serial port.
• Select Reset active bin to reset the active bin for a linked set of bins.
•
Make sure the Serial Buffer menu is set to Enabled.
to confirm.
296
to confirm.