Operating Instructions; General Notes - ORTAL Clear 40 Tunnel, Clear RS Tunnel Installation & Operation Manual

OPERATING INSTRUCTIONS

GENERAL NOTES

Radio Frequency Handset
433.92 MHz for Europe; 315 MHz for U.S. (FCC ID:
RTD-G6R) and for Canada (IC: 4943A-G6R).
This device complies with part 15 of the FCC Rules. Op-
eration is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) This
device must accept any interference received, includ-
ing interference that may cause undesired operation.
party responsible for compliance could void the user's
authority to operate the equipment.
NOTICE
Wiring of valve and receiver must be completed be-
fore starting ignition. Failure to do so could damage
the electronics.
Batteries – Handset:
▪ 1 x 9V (quality alkaline recommended).
▪ Low battery indicator on handsets with display.
▪ Handsets without display: the red LED gets darker.
▪ Battery replacement is recommended after 2 years.
Batteries – Receiver:
▪ 4 x 1.5V "AA" (quality alkaline recommended).
▪ Low battery indication: frequent beeps for 3 seconds
when motor turns.
▪ An AC Mains Adapter may be used instead of batteries.
NOTICE
Only the Mertik Maxitrol AC Mains Adapter or one
preapproved by Mertik Maxitrol can be used. Use of
other adaptors can render the system inoperable.
▪ The module for fan speed control and light/dimmer in-
cludes mains power together with batteries in the re-
ceiver for automatic backup in case of power outage.
▪ Without using a mains adapter, battery replacement is
recommended at the beginning of each heating season.
Temperature setting (page 19)
ON/OFF Temperatures setting (page 19)
Program timer setting (page 19)
Fan operation (page 17)
Modes of operation (page 18)
Figure 20
APPENDIX B
NOTICE
The handsets, receivers, wall switches, switch panels
and touch pads are not interchangeable with previ-
NOTICE
Replacement handsets for CSA models also must
have the same part number (see label).
SETTING THE ELECTRONICS CODE
(First time use only.)
Radio Frequency Handset
A code is selected automatically for all Mertik Maxitrol
electronics from among 65,000 random codes available.
The receiver has to learn the code of the handset:
▪ Press
and the second beep is long. After the second beep,
release the reset button.
▪ Within the subsequent 20 seconds press the
hear one long beep, this indicates the code learning
sequence has failed or the wiring is incorrect.
NOTE: This is a one time setting only, and is not re-
quired after changing the batteries of the hand-
set or receiver.
Figure 22: Receiver Reset Button
°C/24 hour or °F/12 hour Clock
setting (page 18)
15 / 65
FOR OEM USE ONLY
Figure 21: Previous Handset
Signal indicator
Battery status
Time setting (page 18)
Light/Dimmer operation (page 17)
Solenoid Valve/Burner
OPEN and CLOSE (page 17)
Fan level icon (page 17)
A p p e n d i x B
(small
-