Chapter Two - Initial Setup; Powering On / Control Menu Bar; Selecting Monitor To Display Menus - Security Labs 960H Series User Manual

Chapter Two – Initial Setup

2.1 Powering On / Control menu Bar

Facing the front of your unit, the main power toggle switch can be easily located by hand in the
top left corner of the back panel. Turn on the power switch and allow approximately 45 seconds
for the unit to boot up and do a quick check of the hard drive. The DVR will automatically
display the Configuration Wizard (first time use), or a colorful control menu bar (pictured below)
can be displayed by hovering the mouse pointer near the bottom of the screen.
Button Description Button Description
Main Menu PTZ Control
Wizard & Language Alarm Control
Multi Channel Display Setup
Recording Control
Exit
Playback & Backup
TIP:
To help you notice important points, or scan the instructions for a quick review in the
future, buttons or controls that need to be set are printed in BOLD TEXT.
2.2 Menu Display Monitor
You can simultaneously use a standard monitor connected to the Video Out jack, and a higher
resolution monitor connected to the VGA or the HDMI output. One output will only show the
video from your cameras, and can be connected to a public view monitor. The other output will
serve as the main control monitor feed and show the video from your cameras, plus the cursor
movement of the mouse and all menus that you access.
8