Table of Contents
Advertisement
1.2 Rear panel & Connections
Before powering up your new DVR, please connect cameras to the BNC inputs (2), LAN cable
from the Network port (7) to your router (or switch), mouse to a USB port (8) on the back panel
(TIP: Leave the USB port empty on the front panel for easier backup drive access), and the
VGA (6) or HDMI (7) port to a high definition monitor, or the V-OUT jack (4) to a standard
monitor with a video input. If you have a motorized PTZ camera, connect its data control wires
to the RS485 A-B terminals (9) following the instructions that came with the camera. Finally,
connect the included 12VDC regulated power supply (10) that came with your DVR . Caution:
Using a power supply from another source can cause erratic operation, or circuit failure.
Item
1
2
3
4
5
6
7
8
9
10
11
ALARM INPUTS
12
POWER SWITCH
4 Channel Rear Panel
8 & 16 Channel Rear Panel
Interface
AUDIO IN
VIDEO IN
A-OUT
V-OUT
HDMI
VGA
NETWORK
USB
RS485
DC-12V
Description
4 audio inputs
4, 8, or 16 video inputs
1ch audio output
Composite video output
HDMI output
VGA monitor output
RJ45 for LAN (local area network) or WAN (internet)
Additional mouse and USB backup device ports
PTZ (Pan/Tilt/Zoom) camera connection
Power supply input jack
(Optional on some models)
Toggle Switch – "OFF" towards outside of chassis
5
Advertisement
Table of Contents
