Start Stop - Skoda Superb Owner's Manual

Storing and maintaining speed

Read and observe and
›
Activate the cruise control system
›
Drive at the desired speed.
›
Push the rocker button into the SET/-
B
After you have released the rocker button
speed you have just stored is kept constant without having to depress the ac-
celerator.
Changing the stored speed

Read and observe and
Increasing the speed with the rocker button
›
Push the rocker button into the RES/+
B
If the rocker button is held in the RES/+ position, the speed will increase con-
tinuously. Release the rocker button once the desired speed is reached. The
set speed is then stored in the memory.
Decreasing the speed using the rocker button
The stored speed can be reduced by pushing the rocker switch
SET/- » Fig. 151 on page 161 position.
If the rocker button is pressed and held in the SET/- position, the speed will
decrease continuously. Release the rocker button once the desired speed is
reached. The set speed is then stored in the memory.
If the rocker button is released at a speed of less than approx. 25 km/h, the
speed is not stored and the memory is erased. Once the speed of the vehicle
has increased to more than approx. 25 km/h, the speed must then be stored
again by pushing the rocker button
Increasing the speed with the accelerator
›
Depress the accelerator pedal.
Releasing the accelerator pedal will cause the speed to drop again to the set
speed.
Decreasing the speed with the brake pedal
The speed can also be reduced by depressing the brake pedal, which tempora-
rily deactivates the system » page
162
Driving
on page 161 first.
» page 161.
» Fig. 151 on page 161 position.
from the SET/- position, the
B
on page 161 first.
B
» Fig. 151 on page 161 position.
B
B
into the SET/- position.
B
162.
Switching off temporarily

Read and observe
The cruise control system can be temporarily deactivated by pushing the
switch » Fig. 151
A
by depressing the brake or clutch pedal.
The set speed remains stored in the memory.
Briefly push the rocker button
the stored speed after the clutch or brake pedal is released.

START STOP


Introduction
This chapter contains information on the following subjects:
Operating conditions for the system
Operation in vehicles with manual gearbox
Operation in vehicles with automatic gearbox
System related automatic start-up
Manually deactivating/activating the system
into the
Information messages
The START STOP system (hereinafter referred to as the system) saves fuel and
reduces polluting emissions and CO
when stopping at traffic lights, and starting the engine again when moving off.
WARNING
Never let the vehicle roll with the engine switched off.
■
The brake servo unit and power steering only operate if the engine is run-
■
ning.
and on page 161 first.
on page 161 into the spring-mounted CANCEL position or
into the RES/+ position in order to resume
B
emissions by turning the engine off, e.g.
2
163
163
163
164
164
164