Net Partition (Superb Combi) - Skoda Superb Owner's Manual

Tensioning strap
›
Insert the tensioning strap holders into the opening on the left or right carri-
er rail.
›
Press the holder in the direction of the arrow
ly push in the desired position in the direction of the arrow
›
Ensure that the holder is correctly locked in place.
›
Place the object that is to be secured behind the tensioning strap.
›
Press the button on the top side of the holder and tighten the strap.
5
WARNING
The objects in the boot must be firmly secured with the fixing set so that
they cannot move freely and uncontrollably and to prevent damage to ob-
jects or injuries to occupants.
Note
Do not use the fixing set to secure objects that might damage the fixing set.
■
The tensioning strap can also be fully reeled up by pressing the button
■
» Fig. 117.
5
Movable lashing eyes

Read and observe on page 105 first.
There are four moveable lashing eyelets in the boot that can, for example, be
used to attach the fixing nets.
›
Press the button in the direction of arrow
eyelets to the desired position in the direction of the arrow
›
Fold up the clamp the lashing eyelets
net.
» Fig. 117 and simultaneous-
3
.
4
Fig. 118
Move lashing eyelets
» Fig. 118 and move the lashing
1
.
2
and, for example, attach the fixing
A

Net partition (Superb Combi)


Introduction
This chapter contains information on the following subjects:
Using the net partition behind the rear seats
Using the net partition behind the front seats
Removing and refitting the net partition housing
WARNING
The belt locks and the belts must be in their original position after folding
■
back the seat cushions and backrests - they must be ready to use.
The seat backrests must be securely latched in position so that no ob-
■
jects from the luggage compartment can slip into the passenger compart-
ment under sudden braking – risk of injury.
Ensure that the rear seat backrests are properly engaged. Only then can
■
the seat belt for the middle seat reliably fulfil its function.
Make sure that the transverse rod is inserted into the mounts
■
» Fig. 119 on page 107 or » Fig. 120
C
Using the net partition behind the rear seats

Read and observe on page 107 first.
Extending
›
Pull the net partition by the tab
.
C
›
Insert the transverse rod into one of the mounts
›
Insert the transverse rod into the mount
in the same way.
on page 108 in the forward position.
Fig. 119
Net partition behind the rear
seats in the pulled out state
» Fig. 119 in the direction of the fasteners
A
and push forwards.
C
on the other side of the vehicle
C
Seats and practical features
107
108
108

107