Seat Features - Skoda Superb Owner's Manual

When automatic storage is activated, the current positions of the driver's seat
and the external mirrors are saved in the memory of the remote control key
each time the vehicle is locked. When the vehicle is next unlocked using the
same key, the driver's seat and the external mirrors assume the positions stor-
ed in the memory of this key .
1)
Saving front passenger mirror settings when reversing
Above the MAXI DOT display in the menu item Mirror down The lowering func-
tion for the mirror on the passenger side when reversing must be ena-
bled » page 47.
›
Unlock the vehicle using the respective remote control key.
›
Switch on the ignition.
›
Turn the knob for the external mirror control to the position for the passen-
ger side mirror adjustment » page
›
Engage reverse gear.
›
Adjust the front passenger's mirror to the desired position
›
Disengage reverse gear.
The adjusted position of the exterior mirror is stored in the remote control key
memory.
Disable the function of automatic storage
›
Unlock the vehicle with the remote control key.
›
Press and hold the button
SET
press the button on the remote control key within 10 seconds.

The successful deactivation of the automatic storage function for each key is
confirmed by an acoustic signal.
Stopping the ongoing adjustment
›
Press any button on the driver's seat or the button
key.

Seat features


Introduction
This chapter contains information on the following subjects:
Seat heaters
Ventilated front seats
1) The vehicle must be locked and unlocked with the same key to save the seat and exterior mirror position
to the key.
80.
» page
» Fig. 71 on page 84. At the same time,
A
on the remote control

Convenience features of passenger seat
Front armrest
Rear armrest
Seat backrests
Rear seat folded forward (Superb Combi)
Seat heaters
80.
Fig. 72 Heating: Front seats/ rear seats
The seat backrests and surfaces of the front seats and the outer rear seats
can be heated electrically.
The seat heating can only be switched on when the engine is running.
Switching on the front seat heater
›
Press the controller in the area of the symbols  and 
Switch on rear seat heater
›
Press the symbol button  or 
By pressing the button once, the heating is switched to the highest intensity -
level 3, which is indicated by all three of the warning lights in the switch illumi-
nating.
With repeated pressing of the switch, the heating is turned down until it goes
off.
The seat heating level is indicated by the number of illuminated warning lights
85
in the respective control.
86
» Fig. 72 - 
» Fig. 72 - .
Seats and practical features
87
87
87
87
88

85