Skoda Superb Owner's Manual page 167

Automatic engine shutdown takes place, segment display shows START STOP
ACTIVE or a check mark appears in the MAXI DOT display 
page 163.
Automatic engine start
›
Release the brake pedal.
The automatic start procedure takes place again.
Further information on automatic transmission
The automatic engine shut down takes place when the selector lever is in po-
sitions P, D, S and N and in Tiptronic mode.
When the selector lever is in position P, the engine remains shut down even
after you release the brake pedal. The engine starts automatically by pressing
the gas pedal or by moving the selector lever into a different mode and releas-
ing the brake pedal.
If the engine is off due to the automatic and the selector lever is put to the R
position, then the automatic start-up of the engine.
If the gear selector is moved from position R to the position D, S or N, the vehi-
cle must reach a speed of more than 10 km / h before the automatic engine
shutdown starts.
There is no automatic engine shutdown when the system detects a vehicle
moving due to a large steering angle.
No automatic engine shutdown takes place when the vehicle is moving at low
speed (e.g. during a traffic jam or when turning) and remains stationary after
pressing the brake pedal lightly. Automatic engine shutdown takes place if you
press the brake pedal down with more force.
System related automatic start-up

Read and observe on page 162 first.
When the engine is off, the system can automatically start the engine before
the desired journey continues. Some possible reasons for this are:
›
The vehicle has begun to roll, e.g. on a slope.
›
The brake pedal has been actuated several times.
›
The current consumption is too high.
164
Driving
Manually deactivating/activating the system
» Fig. 152 on

Read and observe
Deactivating/activating
›
Press the  button
When start stop mode is deactivated, the warning light in the button illumi-
nates.
Note
If the system is deactivated when the engine is turned off automatically, then
the automatic start process takes place.
Information messages

Read and observe
The messages and information are indicated in the instrument cluster display.
Start engine manually!

START MANUALLY

One of the conditions for automatic engine start is not satisfied or the driver's
seat belt is not fastened. The engine must be started manually.
On vehicles with the system KESSY the ignition is turned off by the first press
of the start button, only after pressing for the second time is the start process
initiated.
Fault: Start stop

ERROR START-STOP

A system error is present. Seek help from a specialist garage.
Fig. 153
Button for the START STOP sys-
tem
on page 162 first.
» Fig. 153.
on page 162 first.