Skoda Superb Owner's Manual page 210

After changing the wheel, the tyre pressure should be adjusted. In vehicles
with tyre pressure monitoring, tyre pressure values are to be stor-
ed » page 166.
Replace the damaged wheel or consult a specialist garage about repair op-
tions.
WARNING
Drive cautiously and only at a moderate speed until the tightening torque
has been checked.
Loosening/tightening wheel bolts

Read and observe on page 206 first.
Before removing the wheel bolts, the caps for the wheel bolts must be pulled
off.
Releasing
›
Push the wheel wrench onto the wheel bolt as far as the stop
›
Grip the wrench at its end and turn the bolt about one turn in the direction of
the arrow » Fig. 179.
Tightening
›
Push the wheel wrench onto the wheel bolt as far as the stop
›
Grip the wrench at its end and turn the bolt against the direction of the ar-
row » Fig. 179 until it is tight.
After tightening the wheel bolts, the covering caps must be replaced.
1)
Use the appropriate adapter for undoing and tightening the anti-theft wheel bolts
Fig. 179
Changing a wheel: Loosening the
wheel bolts
.
1)
.
1)
» page 208.
WARNING
Undo the wheel bolts only a little (about one turn) provided that the vehi-
■
cle has not yet been jacked up. Otherwise the wheel could become loose
and fall off.
If it proves difficult to undo the bolts, carefully apply pressure to the end
■
of the wrench with your foot. Keep hold of the vehicle when doing so, and
make sure you keep your footing.
Raising the vehicle
Fig. 181 Attach lifting jack

Read and observe on page 206 first.
In order to raise the vehicle, the jack from the tool kit is to be used.
Position the car jack at the jacking point closest to the flat tyre .
Fig. 180
Jacking points for positioning
lifting jack
Emergency equipment and self-help

207