Raising or lowering the curvature of the lumbar support
›
Push the switch
in the region of one of the arrows1
A
The adjusted driver's seat position can be set in the memory of the
seat
» page 84
or the remote control key
Note
If the setting procedure is interrupted, you will need to press the button again.
Head restraints
Fig. 69 Head restraints: Setting / removing
Read and observe
on page 81 first.
Best protection is achieved if the top edge of the head rest is at the same level
as the upper part of your head.
Setting height
›
Grasp the side of the head restraint with both hands and push it upwards as
required
» Fig. 69
- .
» Fig.
67.
» page
84.
Fig. 70
Rear centre head rests in vehi-
cles with the TOP TETHER sys-
tem
›
To move the head restraint downwards, press and hold the safety but-
ton
» Fig. 69
- with one hand and push the head restraint down with the
other hand.
The head restraints and the front seats must be adjusted to match the body
size at all times and the seat belt must always be fastened properly to provide
the most effective levels of protection to the passengers
safe seated position.
Removing/installing
›
Fold the seat slightly forward before removing the rear head restraint.
›
Pull the head restraint out of the seat backrest as far as the stop.
›
Press the locking button in the direction of the arrow
the head restraint out.
›
To reinsert the head restraint, push it far enough down into the seat back-
rest until the locking button clicks into place.
Removing and installing rear middle head rest
Applies to vehicles using the TOP TETHER system.
›
Pull the head restraint out of the seat backrest as far as the stop.
›
Press the locking button in the direction of arrow
press the locking button into the opening
with a width of maximum 5 mm and pull out the head rest.
›
To reinsert the head restraint, push it far enough down into the seat back-
rest until the locking button clicks into place.
WARNING
With seats occupied, the respective head rests must be installed and cor-
rectly set (may not be in the bottom position) - there is a risk of fatal injury!
Note
The middle rear head restraint is adjustable in two positions.
» page
9, Correct and
» Fig. 69
- and pull
» Fig. 70
simultaneously
1
using a flathead screwdriver
2
83
Seats and practical features