Fig. 210 Seal expand / lighting connector
Read and observe
and
Removing
›
Open the boot lid.
›
Insert the clamp for removing the wheel trims
into the hole at the position indicated by the arrow
›
Remove the cover in the direction of the arrow
›
Use the screwdriver from the tool kit to unscrew the lamp
›
Grasp the rear light and carefully remove away from the direction of travel.
›
Remove the rubber seal in the direction of arrow
›
Pull off the cable bundle with the plug cap
›
Press together the interlocks on the connector in the direction of arrow
» Fig. 210
- .
2
›
Carefully remove the connector from the tail lamp assembly in the direction
of the arrow
.
3
Fitting
›
Insert the connector into the lamp and lock it securely.
›
Install the rubber seal in the body in the opposite direction to arrow
stall
» Fig. 210
- .
›
Insert the tail lamp with the holes
the body
» Fig. 210
- .
›
Carefully press the tail light into the bolts on the bodywork.
Ensure that the wiring harness does not become pinched between the body
and the lamp.
›
Screw the tail lamp into place and install the cover.
›
Ensure that the cover engages firmly.
on page 224 first.
» page
205, Vehicle tool kit
» Fig. 209
- .
» Fig. 209
- .
» Fig. 209
» Fig. 210
- .
1
» Fig. 210
- .
» Fig. 211
on page 227 into the bolts on
1
CAUTION
Ensure that the vehicle paintwork and the tail lamp are not damaged when re-
moving and installing the tail lamp.
Replacing bulbs in rear light (Superb Combi)
Read and observe
›
Turn the bulb holder
from the lamp housing.
- .
›
Push the faulty bulb into the holder, turn in anti -clockwise direction up to
the stop and remove.
›
Insert a new bulb into the holder and turn in a clockwise direction to the
stop.
›
Replace the holder with the bulb into the lamp housing and turn in a clock-
wise direction to the stop.
in-
1
Fig. 211
Replacing the light bulb
and
on page 224 first.
» Fig. 211
in an anti-clockwise direction and remove it
2
Fuses and light bulbs
227