Skoda Superb Owner's Manual page 123

■ Starting time 1, Starting time 2, Starting time 3 - for each pre-set time, the
day and the time (hour and minute) can be set for switching on the auxiliary
heating. An empty position can be found between Sunday and Monday when
selecting the day. If this empty position is selected, the activation is per-
formed without taking into account the day.
Activate - Activate pre-set mode;
■
■ Deactivate - Deactivate pre-set mode;
Factory settings - Restore factory settings
■
Back - Return to main menu
■
Only one programmed pre-set time can be active.
The last programmed pre-set time remains active.
After the auxiliary heating activates automatically at the set time, it is neces-
sary to pre-set a time again.
If the menu item Back is selected or no changes are made on the display for
longer than 10 seconds, the set values are stored, but the pre-set time is not
activated.
The system switches itself off at the end of the running time set under the
menu item Running time.
Note
A warning light on the button  » Fig. 127
ning.
Radio remote control
120
Operation
illuminates when the system is run-
Fig. 128
Auxiliary heater: Radio remote
control

Read and observe and
Explanation of graphic » Fig. 128
Aerial
A
Warning light
B
Switch on the auxiliary heating

Switch off the auxiliary heating

The transmitter and the battery are housed in the housing of the remote con-
trol. The receiver is located in the interior of the vehicle.
When the battery is fully charged, the range of the remote control is a few
hundred metres. Obstacles between the remote control and the vehicle, bad
weather conditions and a weaker battery in the remote control can clearly re-
duce the range.
To switch the auxiliary heating on or off, hold the remote control vertically,
with the aerial pointing upwards. The antenna must not be covered with
A
the fingers or the palm of the hand during this process.
The auxiliary heating can only be switched on/off safely using the radio re-
mote control, if the distance between the radio remote control and the vehicle
is at least 2 m.
After pressing the button, the warning light in the remote control gives the
user different kinds of feedback:
Display warning light » Fig. 128
B
Lights up green for around 2 seconds.
Lights up red for around 2 seconds.
Slowly flashes green for around 2 sec-
onds.
Quickly flashes green for around 2
seconds.
Flashes red for around 2 seconds.
Lights up orange for around 2 sec-
onds, then green or red.
on page 119 first.
Meaning
The auxiliary heating has been
switched on.
The auxiliary heating has been
switched off.
The ignition signal was not received.
The auxiliary heating is blocked, e. g
because the tank is nearly empty or
there is a fault in the auxiliary heat-
ing.
The switch off signal was not re-
ceived.
The battery is weak, however the
switching on or off signal was re-
ceived.
