Table of Contents
Advertisement
5.2-4-2 Installing Drivers with Existing Windows NT 4.0
WARNING: If you wish to use your current bootable drive with the
Windows NT4 operating system on the Ultra100, perform the steps
below while the boot drive is still attached to your existing onboard
IDE controller. Do not attach any drives to your Ultra100 until the
steps below are complete.
1.
Choose "Settings" from the "Start" menu.
2.
Choose "Control Panel" from the "Settings" menu.
3.
Double-click on the "SCSI Adapters" icon, which generates the
"SCSI Adapters" dialog box.
4.
Choose "Drivers," and then press "Add."
5.
In the "Install Drivers" dialog box, press "Have Disk..."
6.
When the "Install From Disk" appears, insert the "Ultra100 Driver"
diskette in drive A:.
7.
Type "A:\NT4" in the text box, then choose "OK."
8.
When the "Install Driver" dialog box appears, select "Win NT Prom-
ise ULTRA100 (tm) Controller" and then press "OK."
9.
When the "Select SCSI Adapter Option" dialog box appears,
press "Install."
10. After a successful installation, the "SCSI Adapter Setup" box will
show that the "Win NT Promise ULTRA100 (tm) Controller" driver
has been installed.
11. Power off your system, and then attach your hard drive(s) (see
page 7 for more details) to the Ultra100 controller card.
5-10
Hide quick links:
Advertisement
Table of Contents
