MSI 694D PRO Manual page 92

5.2-3-2 Installing Drivers with Existing Windows 98
The following section details the installation of Ultra100 drivers on a
system that has Windows 98 already installed. If you're installing the
Ultra100 drivers on a system during a Windows 98 installation, see
"Installing Drivers During Windows 98 Installation."
1. After installing the Ultra100 controller card and configuring the
hard drives, power up the system and boot Windows.
2. The "Add New Hardware Wizard" will appear, informing you that
it has found a "PCI Mass Storage Controller."
3. Click on "Next," and from the generated list box, choose "Search
for a better driver than the one your device is using now."
4. Click on "Next," and from the generated choices, choose
"Specify a location."
5. Type "A:\WIN95-98" in the text box that appears.
6. Insert the "Ultra100 Driver" diskette in drive A:.
7. Click on "Next." A message informing you that Windows has
found "Win95-98 Promise ULTRA100 (tm) IDE Controller"
should appear.
8. Click on "Next," and then on "Finish."
9. Choose "Yes" when asked if you want to restart your computer.
Be sure to eject the diskette from drive A:.
Confirming Driver Installation in Windows 98
To confirm that the driver has been properly loaded in Windows 98,
perform the following steps:
1. Choose "Settings" from the "Start" menu.
2. Choose "Control Panel," and then double-click on the "System"
icon.
3. Choose the "Device Manager" tab, and then click the "+" in
front of "SCSI controllers." "Win95-98 Promise ULTRA100 (tm)
IDE controller" should appear.
5-8