Table of Contents
Advertisement
will load support for the following mass storage devices:" The list
will include "Win2000 Promise Ultra100 controller"..
NOTE: If you need to specify any additional devices to be
installed, do so at this time. Once all devices are specified,
continue to step 7.
From the Windows 2000 Setup screen, press the Enter key. Setup will
now load all device files and then continue the Windows 2000
installation.
5.2-1-2 Installing Driver in Existing Windows 2000 System
WARNING: If you will be moving the boot drive containing the exist-
ing Windows 2000 operating system to the Ultra100 card, the Ul-
tra100 driver MUST be loaded on to this hard drive while it is still
attached to your existing hard drive controller. Do not attach this
drive or any other hard drive to the Ultra100 controller card before
completing this step.
After installing the Ultra100 card and rebooting your system, Windows
2000 setup will show a "New Hardware Found" dialog box.
1.
In the dialog box, choose "Driver from disk provided by hardware
manufacturer" button.
2.
In the A: drive, insert the Ultra100 driver diskette.
3.
Type "A:\WIN2000" in the text box. Press "Enter".
4.
Choose "Win2000 Promise Ultra100 IDE Controller" from the list
that appears on screen, then press the "Enter" key.
5.
The Windows 2000 Setup screen will appear again saying "Setup
will load support for the following mass storage devices –
Win2000 Promise Ultra100 IDE controller". The Ultra100 driver
will now be copied on to the system and entered into the Win-
dows 2000 driver database.
6.
When the "System Settings Change" dialog box appears, remove
the floppy diskette and click on "Yes" to restart the system. Win-
dows 2000 will then restart for the driver installation to take effect.
5-3
Hide quick links:
Advertisement
Table of Contents
