MSI 694D PRO Manual page 90

5.2-2-2 Installing Drivers with Existing Millenium System
The following section details the installation of Ultra100 drivers on a
system that has Millenium already installed and running. If you're
installing the Ultra100 drivers on a system during an installation of
Millenium, see "Installing Drivers During Millenium Installation."
1. After installing the Ultra100 controller card and configuring the
hard drives, power up the system and boot.
2. The "Add New Hardware Wizard" will appear, informing you that
it has found a "PCI Mass Storage Controller."
3. Click on "Next," and from the generated list box, choose "Search
for a better driver than the one your device is using now."
4. Click on "Next," and from the generated choices, choose
"Specify a location."
5. Insert the "Ultra100 Driver" diskette in drive A:.
6. Type "A:\WINMILL" in the text box that appears.
7. Click on "Next." A message informing you that Millennium has
found "Windows Millennium Promise ULTRA100 (tm) IDE
Controller" should appear.
8. Click on "Next," and then on "Finish."
9. Choose "Yes" when asked if you want to restart your computer.
Be sure to eject the diskette from drive A:.
Confirming Driver Installation in Millennium
To confirm that the driver has been properly loaded in Millennium,
perform the following steps:
1. Choose "Settings" from the "Start" menu.
2. Choose "Control Panel," and then double-click on the "System"
icon.
Choose the "Device Manager" tab, and then click the "+" in front of
"SCSI controllers." "Windows Millennium Promise ULTRA100 (tm)
IDE controller" should appear.
5-6