Table of Contents
Advertisement
5.2-4 Windows NT 4.x
5.2-4-1 Installing Drivers During New Windows NT 4.0 Installation
1.
Start the system installation by booting from the Windows NT
disk:
a) Floppy install: boot the system with the Windows NT installa-
tion diskettes.
b) Floppyless install: boot from floppy and type "WINNT /B".
After files have been copied, the system will reboot. On the
reboot, press the "F6" key when the message "Setup is in
specting your computer's hardware configuration..." appears.
c)
CD-ROM disk install: boot from the CD-ROM disk and press
the "F6" key when the message "Setup is inspecting your
computer's hardware configuration..." appears.
2.
When the "Windows NT Setup" window is generated, press "S"
to Specify an Additional Device(s).
3.
Press "O" to select "Other" and press the "Enter" key.
4.
Insert the Promise Technology driver diskette into drive A: and
press the "Enter" key.
5.
Choose "Win NT Promise Ultra100 (tm) Controller" from the list
that appears on screen, then press the "Enter" key.
6.
The Windows NT Setup screen will appear again saying "Setup
will load support for the following mass storage devices:" The list
will include "Win2000 Promise Ultra100 (tm) controller".
NOTE: If you need to specify any additional devices to be in-
stalled, do so at this time. Once all devices are specified, continue
to step 6.
7.
From the Windows NT Setup screen, press the Enter key. Setup
will now load all device files and then continue the Windows NT
installation.
8.
After a successful installation, the "SCSI Adapter Setup" box will
show that the "Win NT Promise ULTRA100 (tm) Controller" driver
has been installed.
5-9
Hide quick links:
Advertisement
Table of Contents
