Overview - Valor 650JLN Owner's Manual

Remote Handset Wall Holder
Fire On/Off Wall Switch
(supplied, recommended)
Wall Finish
May be combustible material.
NOTE: Finished wall surface, includ-
ing tiles, etc., MUST be minimum 3/4"
(19 mm) set back from the front face
of the heater.
Backing Plate required
(sold separately)
Bezel with bar-
rier screen required
(sold separately)
WARNING
!
Some materials or items, although safe,
may discolor, shrink, warp, crack, peel, and
so on because of the heat produced by the
fi replace. Avoid placing candles, paintings,
photos, and other items sensitive to heat
around the fi replace.

Overview

Min.
3/4"
(19 mm)
M i n
. 1 "
c o
m b
( 2 5
u s
m m
t i b
) f o
l e m
r
a t e
r i a
Hearth (if used) may be
combustible material.
HOT HEARTH / FLOOR! The hearth or fl oor
in front of the fi replace may become very
hot when the fi replace heats. Do not use the
hearth as a seat or shelf. Solid wood fl ooring
in front of the fi replace (if allowed) may
shrink during the heating season due to heat.
Framing—See Framing section
Field convertible
from top to rear
outlet
650JL or
650IR
Combustible fram-
ing allowed beneath
fi replace. When the
appliance is installed
directly on carpeting,
tile or other combus-
tible material other
than wood fl ooring,
the appliance shall be
installed on a metal or
wood panel extend-
ing the full width and
recessed depth of the
l
appliance.
Note: Unit projects
forward of fi nished
wall. Allow for tile,
etc.
Minimum 1/2" (13 mm) gap
required below backing plate
to surface of hearth or fl oor in
front for air fl ow. Raise enrtire
unit accordingly.
WARNING
!
QUALIFIED
INSTALLER
19 19