Co-Linear Venting - Valor 650JLN Owner's Manual

H4 series dv gas fireplace heater

Hide thumbs

Table Of Contents

Table of Contents

Co-Linear Vent Installations

• The ﬁ replace dimensions are shown in the

Dimensions section of this manual.

• Place the appliance (ﬁ tted with the co-linear adapter)

near the ﬁ replace opening but allow space for

manipulating the chimney liners on to the appliance.

• Drop the 3-inch diameter ﬂ exible liners into the

chimney from outside.

• Fit the liners to the co-linear adapter paying attention

to inlet and exhaust and move the appliance to its

proper position. Be aware of the minimum liner bend

radius and maximum liner horizontal run shown at

right.

• Fit the termination kit and ﬂ ashing to the exterior of

the chimney.

Secure the appliance to the ﬂ oor or wall if necessary.

Rear or Top Outlet Conversion to Co-Linear

Liners using Valor 556CLA Co-Linear Adapter.

(Generic co-axial to co-linear adapter boxes may

also be used as an alternate to the 556CLA).

Only for use when retroﬁ tting a solid-fuel burning

ﬁ replace and chimney.

The appliance must not be connected to a chimney ﬂ ue

serving a separate solid-fuel burning appliance.

Requires 556CLA Co-Axial to Co-Linear Appliance Adapter (or, alternatively, a generic adapter), two lengths of

3-inch diameter ﬂ exible chimney liner, co-linear termination kit and ﬂ ashing and either high wind vertical vent

terminal cap or a low proﬁ le vertical termination.

556CLA Kit

10"

7-5/8" dia.

collar

3" Inlet & Exhaust

Collars

559CLT Co-Linear Terminal