Framing - Valor 650JLN Owner's Manual

• A non-combustible hearth is not necessary in front of this appliance.
• Note that the unit is installed at the framing stage and fi xed to framing using support angles. See page 31. The
wall fi nish is then installed over the support angles up to the front frame on the unit, on the sides and up to the
stand-offs on the top.
When the appliance is installed directly on carpeting, tile or other combustible material other than wood
fl ooring, the appliance shall be installed on a metal or wood panel extending the full width and depth of the
appliance.
30-3/4" (768 mm)
to wall finish
Combustible framing
allowed beneath fireplace.
When the appliance is
installed directly on
carpeting, tile or other
combustible material
other than wood
flooring, the appliance
shall be installed on a
metal or wood panel
extending the
full width and recessed
depth of the appliance
FRAMING DIMENSIONS
FRAMING IN A CORNER

Framing

Wall Finish
16" (406 mm) min. straight out
or off the top venting.
Allow for elbow if rear vent with rise.
46" (1168 mm) min.
38-3/4" (984 mm) to underside of
header and cavity height
MINIMUM 1/2" (13 mm) space
between bottom of backing
plate and surface of hearth or
floor finish in front for air flow
QUALIFIED
INSTALLER
21 21