Error Messages - Martin RoboScan Pro 918 User Manual

a p p e n d i x b
E R R O R M E S S A G E S
Display readout
LERR (Lamp error)
MERR (Memory error)
CSER (Check-sum error)
****
ShER (Short error)
Hot (Hot lamp)
PTER (PCB temp. error)
FTER (FX temperature error)
C1ER (Color wheel 1 time-out)
C2ER (Color wheel 2 time-out)
FgER (Fixed gobo time-out)
RgER (Rot. gobo time-out)
Appears if...
... the lamp doesn't ignite within 10 minutes
of receiving the 'Lamp ON' command. Likely
reasons are a missing or defective lamp, or
insufficient AC voltage.
...the EEPROM memory cannot be read.
...a software upload is unsuccessful.
... there is no communication between the
control panel and motherboard. This read-
out appears briefly when switching on the
fixture.
... the fixture detects the lamp is ON but no
'Lamp ON' command has been received.
This can occur if the lamp relay is stuck or if
the lamp feedback circuit fails. The fixture
may be operated but remote lamp on/off
may be effected.
... you attempt to strike the lamp within 8
minutes after having switched it off. The fix-
ture will store the 'Lamp ON' instruction and
strike the lamp once the 8 minute period
has elapsed.
...there is a malfunction in the PCB or
effects section temperature sensing circuit.
...the magnetic-indexing circuit malfunctions
(e.g. sensor defective or magnet missing),
or if the effect and/or magnetic sensor
requires mechanical adjustment. After the
time-out, the effect in question stops in a
random position.

Error Messages

What to do
• Check the lamp
• Check that the voltage and frequency
settings match the local supply.
• Contact Martin service personnel for
assistance.
• Reload software, see page 19.
• Check fuses and replace accordingly.
• Check that cable between control
panel and motherboard is connected
properly.
• Reinstall software.
• Contact Martin service personnel for
assistance.
• Wait until the lamp strikes.
• Contact Martin service personnel for
assistance.
• Contact Martin service personnel for
assistance.
28