Error Messages - Martin MAC Viper Profile User Manual

Short code
SHNA
SL W
TINA
UITW
ZFTW
* Adjustment should only be carried out by a qualified service technician with Martin™ service
documentation.
** High temperature warnings are canceled as soon as temperature returns to normal. If temperature
reaches cutoff level, the warning is replaced by a cutoff error message.

Error messages

Error messages indicate that there is a serious problem. The MAC Viper Profile communicates errors as
follows:
• Error messages flash in the display.
• If more than one error is detected, the fixture flashes all errors three times each.
• Errors are shown in the display regardless of display status: they override an inactive display and any
other information that the display might be showing.
• If an error is present, the status LED flashes red.
The possible error messages are listed in Table 4 below
Short code
APER
ARER
BATC
BEER
BRER
BSER
C1ER
CDCM
CDEF
CDPT
36
Long message and explanation
SHUTTER ADJUST
No shutter adjustment data in EEPROM. Shutter may be incorrectly adjusted*.
SAFETY LOOP
A safety loop error occurred but is no longer active. Warning message is cleared at the next
power off/on cycle.
TILT ADJUST
No tilt adjustment data in EEPROM. Tilt may be incorrectly adjusted*.
UI TEMP HIGH
Control panel PCB sensor detects that normal operating temperature is exceeded.**
ZF TEMP HIGH
Zoom/focus PCB sensor detects that normal operating temperature is exceeded.**
Table 3: Warning messages
Long message and explanation
AW POS ERROR
FX wheel position electrical indexing system timeout.
AW ROT ERROR
FX wheel rotation magnetic indexing system timeout.
BAL TEMP CUTOFF
Ballast temperature too high. Lamp is shut down, fans set to max. Error message cleared when
fixture is reset.
BEAM SHAPER POS
Prism position magnetic indexing system timeout.
BEAM SHAPER ROT
Prism rotation magnetic indexing system timeout.
BEAM SMOOTH ERR
Beam smoothing error.
COLORWHEEL 1 ERR
Color wheel position magnetic indexing system timeout.
CAL DATA CMY
Valid color mixing calibration data not detected in EEPROM. Fixture may be unable to read/write
color mixing calibration data to EEPROM.
CAL DATA EFFECT
Valid effects calibration data not detected in EEPROM. Fixture may be unable to read/write
effects calibration data to EEPROM.
CAL DATA P/T
Valid pan/tilt calibration data not detected in EEPROM. Fixture may be unable to read/write
pan/tilt calibration data to EEPROM.
Table 4: Error messages
MAC Viper Profile User Guide
: