Adjusting The Hoops - Bernina Artista 165 User Manual

Attaching the embroidery hoop
Adjusting the embroidery hoop
Needle and presser foot
· raise the needle and presser foot
· hold the hoop with the right side of
the fabric facing up and the
attaching mechanism to the left
· pass it under the presser foot
Attaching the hoop
· squeeze the ends of the attaching
mechanism on the side of the hoop
· position the center points of the
hoop (small raisings) over the
bracket of the embroidery arm
· press down on the hoop until it
engages
· release the attaching mechanisms
of the hoop
If the embroidery module was not
bought with the sewing computer
but as a later addition, it is necessary
to adjust the embroidery hoop
Preparation
· the embroidery module must be
attached directly to the sewing
computer without the adapter
· attach the large or medium hoop to
the module with the corresponding
template
Open Setup
· press the external setup button
· the menu appears
· select "Service"
· the menu appears
· select "Adjustment of hoop"
Adjusting the hoop
· the adjustment screen appears
· touch "check"
· the sewing computer follows the
contours of the hoop, finally
positioning the needle in the center
· if the needle does not come to a
stop in the exact center of the
hoop, use the arrows to adjust it
008904.55.04_EMB_0401_a165 a170 a180_EN
Embroidery hoops
Removing the hoop
· press both ends on the hoop atta-
ching mechanism towards each
other
· pull up to remove the hoop
before using it for the first time. This
adjustment calibrates the needle to
the center of the embroidery hoop.
· touch "ok"– close the screen
· close setup with "esc"
· touch "check" in Layout 1 – close
embroidery hoop adjustment
19