Bernina Artista 165 User Manual page 16

16 Messages
MESSAGE
Card exchange was not accepted. Possible loss of data!
Please refer to your instruction manual before
exchanging cards.
Your personal design card is full, or you have
inserted a programmed design card which you
cannot save.
Please insert a BERNINA blank card.
Your edited text does not fit in the hoop.
Please shrink the size or rotate the pattern.
More than 20 characters cannot be edited.
Please check the upper thread.
The bobbin winder is on.
Do you really want to delete the contents of
this memory?
Insufficient memory for this function.
This motif can be moved around and embroidered.
No embroidery hoop attached.
Your personal memory capacity is full. Use a blank card
to save the motif, or delete a motif in your personal
memory capacity.
Designs that have been downloaded from the PC
embroidery software cannot be altered in size within
the machine.
RESPONSE
· Never remove a card from the embroidery module
when the hourglass is blinking!
· If your personal memory card does not work after the
exchange, it must be reformatted (see p. 36).
· appears when the sewing computer is unable to save
to the card inserted into the module.
· touch "esc" to return to the previous screen.
· appears when the store function has been selected
and there is no card inserted into the embroidery
module.
· insert a personal design card and touch "esc" to
return to the previous screen.
· continue with the saving process by touching store
again.
The letter combination chosen is too large to stitch in
the hoop. Rotate the letters 90° or reduce the size to
fit in the hoop.
· shrink the size of the letters (in layout) or work stage-
by-stage.
· check to see if the needle thread has run out or has
broken.
· rethread the needle if necessary. The sewing
computer will not sew until this is corrected.
· touch "esc" to return to the previous screen.
· check to see if the bobbin winder is on. If the bobbin
winder is on, the foot pedal is inactive and the
sewing computer will not sew.
· disengage the winder if needed. The sewing
computer will not sew until this is corrected.
· Note: This message will appear when winding a
bobbin: touch "esc" to clear it from the screen.
· confirm the delete command before the contents of
the memory are erased.
· touch "yes" to continue with the deletion process
· touch "no" to stop the process.
· The memory capacity is too small to convert this many
stitches.
· appears when a letter or motif is selected without a
hoop on the embroidery module.
· touch "esc" and attach the appropriate hoop to the
embroidery module.
· go to layout 1 and touch "check" so the embroidery
module can recognize the hoop.
· appears if the memory in the embroidery module is
full.
· a design in the memory must be deleted or a new
memory card inserted.
· Edit the motif using the PC software and then load on
the machine again or
· save the motif on a memory card or on the
embroidery module and then edit.
008904.55.04_EMB_0401_a165 a170 a180_EN