Removal; Internal Battery - ashtech Z-Xtreme Operations & Reference Manual

4. Insert the card (side with insertion arrow face down) into the memory slot.
5. Slide the PCMCIA card all the way into the memory slot of the Z-Xtreme.
All PCMCIA cards are keyed so they only seat into the card connector one
way. While this feature assists in the insertion of the card, it is possible to
force the card into the connector improperly. Improper installation of the PCM-
CIA card may damage the Z-Xtreme.
6. Ensure the PCMCIA card properly seated.
7. Close and latch the memory/battery door.

Removal

Perform the following steps to remove the PCMCIA card.
1. Ensure recording has stopped (either issue a "stop session" through the front
panel, or issue a $PASHS,REC,S command, or turn the receiver off).
2. Orient the Z-Xtreme so that you are looking at the front panel.
3. Open the memory/battery door on the front of the Z-Xtreme.
Attempting to extract a PCMCIA card while the receiver is recording might
result in loss of up to five minutes of recorded data. Disable data recording or
power the receiver off prior to removing the card.
Whenever you stop data recording to insert a new PCMCIA card, data recording will resume as soon
as the new card has been inserted, recognized as valid, and the system has verified there is enough
memory to continue data recording.
4. Depress the PCMCIA ejection button to eject the card from its slot.
5. Grasp the PCMCIA card and remove it.
6. Close and latch the memory/battery door.

Internal Battery

Using the Z-Xtreme in a field environment requires a battery (internal and external
models are available—the receiver will default to the external battery if it is
connected). This section covers only the internal battery.
22
CAUTION
CAUTION
Z-Xtreme Operations and Reference Manual