Send Error Code; Scan To Smb Error Codes - Kyocera FS-6525MFP Service Manual

1-4-6 Send error code

This section describes the scanning errors and descriptions, preventive actions, as well as corrective actions.
Error codes not described here could fall within software errors.
If such an error is encountered, turn power off then on, and advise the service representative.

(1) Scan to SMB error codes

Code
1101 Host destined does not exist on the net-
work.
1102 Login to the host has failed.
1103 Destined host, folder, and/or file names
are invalid.
1105 SMB protocol is not enabled.
2101 Login to the host has failed.
2201 Writing scanned data has failed.
Contents Check procedures/corrective measures
1. Confirm destined host.
2. Confirm device's network parameters.
3. Confirm the network parameters the device is con-
nected.
1. Confirm user name and passowrd.
2. Confirm the network parameters the device is con-
nected.
3. Check the host if the folder is properly shared.
1. Check illegal characters are not contained within
these names.
2. Check the name of the folder and files conform with
the naming syntax.
3. Confirm destined host and folder.
1. Confirm device's SMB protocols.
1. Confirm destined host.
2. Confirm that the LAN cable is properly connected to
the device.
3. Check the SMB port number.
4. Confirm device's network parameters.
5. Confirm the network parameters the device is con-
nected.
1. Check the scanning file name.
2. Confirm device's network parameters.
3. Confirm the network parameters the device is con-
nected.
1-4-35
2MW/2MX